Assembly Instructions

Your portable Gift-Wrap Center is easy to assemble in just a few easy steps.

Step 1: Lay the wrap center on the floor with the hinged side facing down.

Step 2: Use one hand to balance the wrap center as you use the other hand to extend each of the steel legs, making sure that each leg-brace locks into position.

Step 3: Then carefully lift the table to a standing position. Your wrap center is now ready for use!

Usage Instructions

Do not sit, stand or lean on the wrap center. Maximum recommended weight capacity is 20 pounds.

To keep the wrap center balanced and stable, always open the lid from the center, using the center thumb tab as shown.

Always make sure that the additional storage compartment lid is firmly snapped shut before opening the larger lid.

To clean you wrap center, use warm soapy water. Do not use household cleaning products that contain harsh chemicals. They could damage your product.

Large Storage Compartment

The Portable Gift-Wrap Center will store up to 36 rolls of gift wrap. Store jumbo rolls of gift wrap (up to 40" in length) in the back section. Rolls measuring 30" or smaller can be placed in the front section.

Additional Storage Compartment

Always make sure that the additional storage compartment lid is firmly snapped shut before opening the larger lid.

Middle Compartment:
The middle section is designed to keep papers flat, making it ideal for tissue paper, flat wrap, cards, envelopes, gift bags and dress shirt style gift boxes. It is also perfectly sized to hold 12" by 12" scrapbook paper.

Side Compartments:
These smaller areas are designed for tools (scissors, pens, rulers, etc.), gift tags or bows.

Accessory Caddy

Insert the accessory caddy into the pocket on the right-hand side of thewrap center. Fill with your preferred tools, such as scissors, pens, rulers, glue sticks, etc.

Tape Dispenser:
Place an invisible tape refill roll on the top spindle and feed the tape onto the metal cutter. Keep a second roll of tape handy on the lower storage spindle.

Ribbon Dispenser:
Step 1: Remove the dowel from the ribbon dispenser.

Step 2: Slide the spools of ribbon onto the dowel.

Step 3: Snap dowel into place in the ribbon dispenser.

Step 4: Feed the end of each ribbon through an opening in the ribbon dispenser. Two or more narrow ribbons may be fed through one opening if desired.

Note: Narrow ribbons that tend to unwind easily may be pinned to the spool to prevent unwinding when not being dispensed.

Roll Dispenser Clips

Insert roll dispenser clips into the two pocket either on the left-hand side or the back of the wrap center (It is important that you use both dispenser clips). Slip roll into clips as shown. Hold the leading edge of the paper and gently pull it away from the roll to the desired length.

Scissor Cutting Guides

Step 1: Unroll desired amount of paper using dispenser clips.

Step 2: Feel through the paper to find the scissor guide underneath. Mark the location of the scissor guide by making a small crease in the paper.

Step 3: Insert scissors into the groove of the scissor guide.

Step 4: Gently make a short cut in the paper to get trimming started, then glide the scissor blade through the paper to complete the process.

* Please note: When cutting thin or delicate papers, It may be necessary to hold the paper with you free hand while trimming.

Smooth Writing Surface

The center panel is designed as a smooth writing surface – ideal for addressing cards, tags and working on craft projects.